Updating Model Parameters from Frequency Domain Data via Reduced Order Models

MI Friswell & JET Penny (Aston University)

Mechanical Systems and Signal Processing, Vol. 4, No. 5, September 1990, pp. 377-391

Abstract

Methods to update the parameters of finite element models using measured vibration data usually use the experimentally derived modal model, that is the system natural frequencies, damping coefficients and mode shapes. The frequency response functions have been used directly to update condensed analytical models and so avoid the sometimes difficult step of deriving the modal model. This paper suggests algorithms to update selected physical parameters of a full finite element model using the frequency response functions. These algorithms are tested on a simulated example.

Paper Availability

This material has been published in the Mechanical Systems and Signal Processing, Vol. 4, No. 5, September 1990, pp. 377-391, the only definitive repository of the content that has been certified and accepted after peer review. Copyright and all rights therein are retained by Academic Press. This material may not be copied or reposted without explicit permission.

Please note that Elsevier Science has bought Academic Press. Although the original paper was published on IDEAL, in future access to this journal will be via ScienceDirect.


Link to paper using doi:10.1016/0888-3270(90)90064-R

Mechanical Systems and Signal Processing on ScienceDirect

ScienceDirect